I recently purchased a used MB20 bed mill with a Cent 6 controller, did some searching and found this forum. Looks like it will be a great resource.

I do have a few questions that I would greatly appreciate any responses to:

My controller has a network connection, but I do not know how to hook the netwoking up. I understand ethernet, TCP/IP and all that (I'm a network administrator full time) but how is the IP of the controller configured? How does the controller pull info from the network (X: drive I'm assuming) - in other words, what needs to be setup on the PC side? I do have the offline SLS software if that is required.

Does anyone else have any issues running the offline software? I've tried in both Windows2000 and WindowsXP with crashes.

Does anyone happen to have a post processor for EdgeCAM?

Thanks for any help.