Hi guys, as all of you know helix bores in mastercam generate a crapload of lines of code, ive been making some aluminum parts 1 piece at a time in the vice and now im building a fixture to hold 28 parts, 2 counterbored flat bottomed holes in each part, 1st operation is ith a 3/8" 2 flute going .875" deep on a .52" diameter hole, next operation for the counterbore is with a 1/2" 2 flute 90 degree drill point drill mill at a depth of .25" to the shoulder with the step on the bore being 45 degrees, hence the reason for using the drill mill. My problem is, the program is way to big, how do i can the helix bore cycles in mastercam so it only has 2 different sets of helix bore code rather than 112 seperate helix bore codes. machine is a haas vf4.