Hi all,
im starting with completing new weike LC1612 dualhead. When i power up both chillers and power up machine im received error message on my both power suplies RECI P12, P16 " water flow error" im checked all hoses and when i start chillers a saw bubles in both laser tubes. I dont know what next i should check. Thanks for any advice.
G.
Results 1 to 2 of 2
Threaded View
-
01-10-2015, 11:26 PM #1
Registered
- Join Date
- Dec 2013
- Posts
- 7
new weike LC1612 water flow problem
Reply With QuoteSimilar Threads
-
G.weike storn 600 direct from weike or full spectrum hobby 5 any advice appriciated
By twistedmonkey in forum G.Weike LaserReplies: 13Last Post: 06-27-2014, 03:32 AM -
G.Weike LC1490 strange cutting problem
By innoc in forum Laser Engraving / Cutting Machine General TopicsReplies: 3Last Post: 04-01-2014, 03:25 PM -
Flow along a surface problem
By zonker in forum Rhino 3DReplies: 0Last Post: 07-06-2010, 11:49 PM -
Determining °C/W of a water-cooled block at different flow rates
By highbias in forum Mechanical Calculations/Engineering DesignReplies: 5Last Post: 10-09-2008, 01:25 AM -
Problem with Data flow between Fanuc 6M and DNC software
By Saluce in forum FanucReplies: 1Last Post: 08-28-2008, 01:20 AM
Tags for this Thread
Posting Permissions
