Hello everyone,
At work recently we bought a G0704 mill with the plans of converting is to CNC. I have the ball screw kit installed and everything seems to be fine there but I just put together all the control electronics and hooked up the motors to test everything and for the life of me I can not get the motors to work.
I'm using a kit from Automation Technology, here's a list of the components in the kit.

(1) KL34H295-43-8B 906oz-in NEMA 34 stepper motor
(2) KL23H2100-50-4B 570 oz-in stepper motors
(1) KL-8070D motor driver
(2) KL-5056D motor drivers
SE-600-48 48VDC /12.5A switching power supply 110VAC/220VAC
C10 breakout board
5V power supply

I'm almost positive that I have everything wired properly(I followed the wiring diagram on Automation Technology's web site) and have all the current and micro step settings on the motor drivers correct. I'm not sure if I have some of the jumper settings on the BOB wrong or if I have the config settings in mach 3 wrong. I've tried many different combinations of jumper settings and config settings but nothing has worked.
Here are the jumper and config settings at the moment.

-C10 jumper settings
Pins 2-9 set to output (pins1-2)
Com set to Com-5V (pins 2-3)
Pins 2-9 set to Pull-Down (pins 1-2)

-KL-5056D Current and Microstep settings
4.9A Peak 3.5A RMS Switch 1 off, 2 on, 3 on.
Standstill Current Switch 4 off.
Microstep 8-1600 Switch 5 off, 6 off, 7 on, 8 on.

-KL-8070D Current and Microstep settings
6.1A Peak 4.3A RMS Switch 1 off, 2 on, 3 on.
Standstill Current Switch 4 off.
Microstep 8-1600 Switch 5 off, 6 off, 7 on, 8 on

-Wiring
(X Axis)
PUL+ to com
PUL- to pin 2
DIR+ to com
DIR- to pin3

(Y Axis)
PUL+ to com
PUL- to pin 4
DIR+ to com
DIR- to pin5

(Z Axis)
PUL+ to com
PUL- to pin 6
DIR+ to com
DIR- to pin7

I've included some pics of my setup.
Attachment 277950 Attachment 277952

Any help would be greatly appreciated
Thanks.