I am thinking about upgrading to Path Pilot and buying a passive probe. I was wondering if PP supports the G31 straight Probe command (G31 - Straight Probe | Tormach Inc. providers of personal small CNC machines, CNC tooling, and many more CNC items.). I did not see this listed in the Path Pilot manual and was curious. Is there a way that I could fully automate probing in Path Pilot? Basically, I would like to have a multi-part fixture plate where I use the probe to locate multiple part’s centers and set each on to a respective G59Px coordinate system. I know there are wizards in both Mach and Path Pilot to do this, but I would like to have a totally automated standalone probing sequence for fixtures.