Hello!

Just received my X6-2200L yesterday. Beautiful machine. Assembled easy. Hooked everything up, plugged it in, and jogged the axis around a bit, and all looked well. Went to the store to grab a tub for water. Hooked up the pump, began pumping, then proceeded to test the spindle. However, when i turned on the control box, the fan in the back didnt turn on, and the motors failed to self lock. No power going to the motors, but the vfd still turned on and display lit up....

Took the top off the control box and with a meter checked the wires going into the 40V PSU, and its receiving the proper 120V, but im not seeing any power coming out of the PSU to the stepper drivers.

I have sent an email to grace at omiocnc, and am awaiting their response. In the meantime, if anyone has any suggestions, im all ears!!

BTW, no the Emergency stop is not pressed. ^^

Thanks!