[syil]

Since we converted CNC for sieg machines.we received many good suggestion from our clinets.without whom this project would not have been so prefect.so we open this thread for every friend to provide good suggestions for us.no matter machines,service.and delivery.any kind advice,we total welcome.
Thanks for every Syil friends and customers

Here some info of Mr Lou update for us and special thanks for Mr Greg Holt too.

By Mr Lou:
1:Attached are two photos that show how I modified the X axis cover. This change has three improvements.
a. an increase in travel by 0.90 inch or 23 mm in the X direction
b. with out the change the cover will bend if the x axis moves too far.
c. The notch for the wires will let the user remove the cover with out having to unplug the cable from the
controller and pull it out of the covering.

2: Adding a cable tie down is necessary for the Y axis sensor. With out it the covering gets caught on the
table and will damage the sensor. It should also be added for the X axis sensor as well.

3:Add a connector to the A axis if it is ordered. This will allow the user to remove the rotary table when it is not in use.

4:Make a Splash Guard Mounted to pretect operater.

5:Mr Greg Holt use another kind itmes to pretect cable of optical sensor.