Well I finally got my Machine hooked up and running after some delay because of damage during shipping but Jack Dong from Shandong Yishun CNC Machinery CO., Ltd. where I purchased it from made sure all parts were replaced and made sure I was happy with everything, I had to install he gantry because it taken off to ship, they walked through every step of the way, after everything that was broke was replaced one of their engineers connected to my pc via Team viewer and mad all the necessary configurations to motors and homing limits and stayed till was happy with everything, I hope to upload a video soon of it running just need a little practice an busy with the honey do list, Over all my experience with Jack Dong as very Good I would recommend him to anyone, the overall of the machine I would rate an 8, there are a few small things such wrong washers being used in hold down slots , not a lot of English manuals, cables and wiring running through holes that were cut that have very rough edge's and should have been protected better, lack of fans in the cabinet cooling, I think its a very solid machine, may not be top of the line but I did not pay top of line price, I have included a few pics If anyone has any comments I would be glad to here them or question's I will try to answer them
Thanks
Steve

YS-1325 CNC Router wood working

1, T-Slot Table for 5/16 t bolt
2, Transmisson : XY Axis Rack Gear Z Axis German Neef Ballscrew
3, XYZ Axis Square rail: 25mm Taiwan HIWIN Square Rail

4, 5.5kw Water cool spindle
5, Delta Inverter
6, Yako drivers
7, 450c Stepper Motor
8, Manual Oil System
9, Full Sets of Collets ER20
10, Full Sets of Wood working cutter
11, rotary Diameter 340mm
12 Mach 3 with all motor setting pre installed
13, 3hp dust collector
14 100' of 6" anti staic hose for dust collector

15 dust boot for spindle