Hello all,

I have just completed the second version of my dusts boot.

The first version was supported from behind (see first picture), after I raised the spindle to get more Z height it conflicted with the Z carriage.
For clearness the dust boot is supported by the X axis.

The support for the new version had to go through the spindle brackets, the height is adjustable from the top.

For easy access the front of the dust boot slides over two pins and is being held in place with four neodidly magnets (AVE:wave.


From now on changing bits and setting Z height will be a lot easier.


Kind regards,

Rob.

P.S.
Do you think its time for a new spoilboard ?