I could use approx 25 of the "F" and 25 of the "R". If your material gives more or less I am flexible.

.002 tolerance is fine.

They are all 7075 pieces and I need a really nice finish around the outer diameter. The inner diameter is not as much as a concern.

I have had these on order with another machinist for about 4 months now and I needed them really bad 4 months ago so, the sooner the better on these. I am hoping for a 3-4 week turn around or something close.

I used a .109 EM on all these parts so please dont be too concerned if the radius' are smaller.

I would need these parts on a semi regular basis. Maybe 2-3 times per year.

Please email me [email protected] (no PM's) with cost and ETA. As said above, I am looking for a quicker turn around so I hope to have these going ASAP.

Looks like it wont let me upload a .stl on here. I can send it in an email. The pictures attached is similar to what I need.