Hi all , I was debating to buy a 4'/4' Saturn router table from FLA . Nate has updated the gantry from aluminum to steel , and I don't doubt the gantry is over 200 pounds .

I would prefer to assemble my own electronics, and have a concern regarding the stepper drivers . If I went with stepper drivers that don't have internal power supplies , then I could load balance the axis by dedicating one PS to the X and Z axis , then dedicate another PS to the Y axis , which I suspect is going to be using the most current .

Heres where the question comes in . I'm liking these stepper drivers that have a built in PS , as I thought it would make for a cleaner and simpler install .
But if I go that route I'll have one dedicated to each axis , and no load balancing. Am I over thinking this ?
Sorry I forgot to mention I'm going with Nema 34 steppers .

These are the ones I was going to purchase and buy 10 amp PS's .
http://www.automationtechnologiesinc...nk-is-included

But these are the ones I'd like to purchase .
https://cnc4pc.com/rsd110-6-ac-line-...tml#prodtabs-3