Hello everyone. Have a Torqcut that is giving me fits. Thought the issue may have been the RPC so I followed mactek54's instructions ,( Thanks very much mactek),and rewired it to 240 single phase, When it goes to start it says " INCOMPATIBLE SOFTWARE VERSIONS DETECTED, You MUST RE-LOAD the executive software by selecting <F9>, LDmdcSW from the initial menu. Hit any key to clear this message. Does anyone have a clue to what it means? Ive got a spare BMDC board coming for in case, but don't want to risk anything. Before the trouble started I had gotten a DOM from EMI, and it appeared ok at first, than this.Looking in the manual it says to contact BMI for updated software. Could something have happened to the DOM? Any help is appreciated.