Originally Posted by
davels
I just try now and with the spindle disconnected the VFD don't stop. I don't have any error message even at 400Hz.
Wiring is ok, I check it before several times. With the beep too to be certain.
I had also check all the male pin of the spindle with the beep but nothing work. I'm not very comfortable to open the spindle as it's new :drowning:
Edit : your second picture show U to R3 and W to R1, is it correct? You write U to Pin 1 and W to Pin 3 (as it's wired currently on my spindle)