Hello,
All started yesterday, when i turned on the machine in the morning. I started the program, and the work speed was very low not normal on x and z axes. I mean the drilling speed was decreased twice. So i called our company electrician he started to look through % switcher on control panel. But then he found some short circuits on CPR board and fixed them (replaced some components on board or smth). After that our machine started to not fully load, when the machine boot's up we got an error with message cpr problem. Then the electrician took out the board again did smth. and now machine boots up olmoust normaly, but not all buttons working and we have the error now 980 fault-c panel/crp receive 8 . Maybe someone can give us advise where to look for smothing? We tried to look from forum's about this problem we stuck now.
i upload some photos.