Re: DMM Servos with DYN4 Drives on G0704 Random Alarm Issue
Originally Posted by mikegiraud
Ok, I'm understanding a bit better. My max frequency settings are set at the default 256. I don't have homing setup yet, so the homing speeds are all 0 at the moment.
Ok in General Config. for Mach3 look for Lock Rapid if this is checked uncheck it and try again you may be able to lower the rapid moves with the slider on the Mach3 screen under feed rate slider for Rapid this will help to not over load the motors
We use cookies to optimize our website for you and to be able to improve it continuously. By clicking the "Accept" button, you expressly agree to the use of cookies. For further information on cookies, please refer to our privacy policy.