I’m trying to wire the steppers, motors and BOB for a cnc router still the school I’m teaching
The motors ARE wired to the steppers now I need to complete the wiring to the bob.
Since it was sold to me as a 6 Axis board, I can’t figure out where the wiring goes.
Of course some is printed in Chinese.
I’ve managed to locate the wiring for the motors to the KL’s but I’m confused about the rest.
I’ve watched countless TouTube videos....
But I’m not sure.
5V, 24V.... checks out on the BOB.
So how do I power the KL’s?
Is it 110V or is it 24V or is it 5V? And how do I do that?





.


Sent from my iPhone using Tapatalk