As the title says I'm looking for the head casting bolt torque on my 1100M. These are the six 12mm socket head cap screws that fasten the head casting to the Z axis saddle. I'm asking because I had to adjust the head in X and Y to get the tram where I wanted it. It was out about .003". I got it trammed in to less than .001" after working on it most of today. What a PITA! Anyway, I'd like to torque the bolts to factory specs.

BTW - I adjusted the head tram after performing the squaring procedure laid out in the Tormach technical document. I got the table level within .0005" and the bed twist is almost perfect. The bubble on my precision level barely moved when I ran the table from Y max to Y min.

Thanks