Hi,

I am planning on changing the four stock TX14207 stepper motor drives for some TB6600 models. I'm fairly new to machining and with my new CNC router and I noticed that the stepper motors sometimes make a bit of noise while they are idle. It seems the TX14207 drivers are no good, there is no support, and I haven't found any information on how to correctly set the dip switches on them. I've quickly read that the TB6600 are stable and are well supported and they are pretty affordable.

If I decide to change these for the TB6600, do I simply require to swap the wiring and set the new dip switch settings or must I also require to bring any changes to the motion controller board and/or make changes to the Mach3 software?

Thanks,
Leo