Hello, all.

I was just setting up a touch probe for my router with the xulifeng motion card and ran into an issue.

When I jog y plus or x minus, the digitize light comes on and stays on until I jog in the opposite direction. The probe input is ignored.

My ports and pins are configured correctly as far as I'm aware. I can use the probe unless I jog y plus or x minus first. Then I get an error. The led on both the card and the touch probe both indicate they are working properly.

Any suggestions?

I tried this on 2 laptops, and a PC. Both laptops do it, the PC works properly. I'm using the same configuration files.