Been trying to figure this out for 3 days and I'm totally lost.

The main problem is that most tutorials I'm watching are either talking about Mach3 or are demonstrating on an older version of Mach4.

Here's what I have;
- Mach 4 Build 4470
- Warp9 ESS
- MB3 BOB from CNCroom

I have Mach4 communicating with the ESS and BOB with no issues
The DROs works properly on the Mach4 screen on all 3 axis.
I have power to my stepper drives, but a bit confused as to which pins are to be used on the BOB.

The output LED ( DIR +) on the BOB comes on solid when travelling in the minus (-) direction only, but I don't have a wire connected to this pin. I wired my stepper drive to " VCC, STEP-, and DIR- ".
No other LEDs come on regardless of direction of travel.

I think I have all parameter filled out on both the Mach configure screen as well as the Warp9 screen, but not 100% sure

My problem is that I have no motor movement.

I've looked at most videos on this, but I'm now more confused as ever as what to check next.
Any help or direction to help me figure this out would be greatly appreciated.

FWIW, I'm older and don't do well when it comes to reading volumes of technical manuals, and don't have any experience with Mach4.

Thanks in advance.