Hi Guys

I'd appreciate if someone with experience of tormach / g-code could cast their eye over this.

I have done drilling operations before with no issues but this has me stumped.

Scenario - step 4 of a program (I'm having to run them individually as the ATC is offline).

1 to 3 work fine, All tools are correctly measured and offset.

Then this simple drilling operation is run. In this case the drill is driven deep beside the work for no reason I can see. Then dragged into the side of the work (snap) and across to the start point of the hole. The chuck then raises and the program works as I would expect it to. Then it slams back down far too deep into the work.

The code was created in Fusion 360 and the simulation runs fine. The post processsor has not changed. The machine has been updated to 2.7.3 but I rolled it back to 2.7.2 and it still does the same thing.

I"d appreciate any insights !