3.2kw Jianken 4 pole and Fuling 5.5kw Vfd. Details are in my other thread.
I have a 2.2kw non atc spindle (220v 1 phase, 2 pole,24k) barely running with the Fuling Vfd .
problems:
1) It seems to run ok in vf mode, but a little wierd in svc.
2) running from the keypad only, no jog, not speed change with pot, only by changing H value.
3) as per another thread, changing motor parameters causes other to change, but tuning is locked out
I would like to get at least the freq changing solved before going much further.
What is the best way to upload my parameters, or is there a generic cheat sheet circulating around here?
Also, I am thinking of putting the vfd in a steel enclosure but I would have to take the keypad out of the plastic enclosure and mount it elsewhere.
I have a steel enclosure with fan, filters, etc that might keep the vfd happy, dust, oil, flood coolant free.
Any thoughts on this?
thanks in advance.