I am looking for some help. I have a Romi M-17 lathe with a fanuc 21I-T control. The issue I am dealing with is the battery died and lost all the presets from Romi. I have the disk with the info on it but can’t get it into the machine. I reached out to Romi and they looked up the machine and sent me the file to make sure I had the right one and still nothing. I am thankful they sent the files over but when I asked for the simple instructions to re install they told me they will quote out a repair visit. Is anyone else getting tired of this BS with machine manufactures’??? I don’t have a warranty and they are in KY and will cost thousands of $$$ to have them come load a simple program. This is why I fully support the right to repair movement.