[QUOTE=joeavaerage;2512696]Hi,
60VDC 600W would be adequate, but 80VDC and 1000W would be better. These large power supplies are expensive and most people buy switchmode supplies on the basis
of cost....but they are not the best choice. Linear supplies are far more rugged and forgiving of overload.
Craig, if you have the time and interest....would you mind elaborating on this subject a bit? How and Why are they more "rugged'? What makes them superior to a switching PS?
Results 1 to 20 of 45
Threaded View
-
06-22-2022, 03:29 PM #7
- Join Date
- May 2022
- Posts
- 27
Re: Ready to pull the trigger and could really use some input.
Reply With QuoteSimilar Threads
-
Looking to pull the CNC conversion trigger
By 91TSiGuy in forum RF-45 Clone MillReplies: 124Last Post: 05-15-2019, 03:56 AM -
Ready to pull the trigger on a CNC router
By uwpeng in forum WoodWorking TopicsReplies: 5Last Post: 11-18-2017, 03:44 PM -
Considering a PlasmaCam,should I pull the trigger?
By Alleykat in forum PlasmaCamReplies: 17Last Post: 05-05-2017, 01:22 AM -
Before I pull the trigger on a build .
By Kru82 in forum DIY CNC Router Table MachinesReplies: 17Last Post: 03-07-2015, 10:02 PM -
About to pull the trigger but have questions.
By phylo in forum Laser Engraving / Cutting Machine General TopicsReplies: 1Last Post: 04-20-2012, 06:06 PM
Tags for this Thread
Posting Permissions
