587,245 active members*
3,382 visitors online*
Register for free
Login
IndustryArena Forum > OpenSource CNC Design Center > Arduino > Bad cut on angled lines and arc

Thread: Bad cut on angled lines and arc

Results 1 to 20 of 37

Threaded View

  1. 07-03-2022, 01:32 PM #21
    Arche
    Arche is offline
    Join Date
    Jun 2022
    Posts
    30

    Re: Bad cut on angled lines and arc

    Thanks for suggestion.
    So I did test. I added photos. It is little bit challenge because both 20° and 70° were smooth, not so perfect like straight cut but smooth.
    It was very difficult to tell what is worse. So I raised feed rate to 4000mm and spinde RPM to 24000 ( I never use that ) and it seems
    how pattern shows that 20° is worse. It shows wavy pattern that sometimes occurs on straight cut on Y (but not so intense). This wave reminds me balls inside carriage how they rolls, just my guess ?
    Attached Thumbnails Attached Thumbnails schema.jpg   20vs70.jpg  
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Machine can't cut straight angled lines.
    By shawnmelton in forum Avid CNC
    Replies: 3
    Last Post: 03-10-2019, 04:29 AM
  2. V-groove bearings on flat or 45 angled profile - bad idea?
    By Spikes in forum DIY CNC Router Table Machines
    Replies: 2
    Last Post: 03-28-2018, 03:34 PM
  3. MasterCam X arc or many lines...?
    By skmetal7 in forum Mastercam
    Replies: 5
    Last Post: 08-26-2014, 08:20 PM
  4. problem with angled cut
    By da_Rayman in forum CNC Plasma / Oxy Fuel Cutting Machines
    Replies: 19
    Last Post: 11-22-2012, 09:28 AM
  5. NOT break arc into lines
    By cncuser1 in forum Mastercam
    Replies: 8
    Last Post: 05-08-2008, 02:48 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules