I have a 1989 Mori Seiki SL-15 with a Fanuc 10T control. Had to have the spindle servo control repaired, afterwards had to reload parameters. That's where the fun starts...

In the Handy Settings page I cannot set the input unit to inch mode, I enter 1 but does not change from 0.

PC Data table settings does not have the D108 (number of turret stations) or D110 (lube pump counter) settings to define.

Parameter 0010 (mm:inch) cannot change to 1.

There are 8 9XXXX series parameters that do not match my document that displays "LOCKED PARAMETER" when I try to change them.

When machine is on the message is OT 002 Z over travel (soft 1) is displayed.

The ERR light is on also.

Any guidance is greatly appreciated.

Thanks!!