[justjedi]

Hello!

I am struggling here a little bit attempting to convert my CNC router from a DSP A11 pendant to UCCNC ethernet motion controller BOB combo.
I like the adaptability of the UCCNC interface and the fact that it is compatible with MACH 3 or 4 which I am familiar with already. Am I correct in assuming I can remove the Richauto BOB and replace it with this C94 Multifunction board relatively easily? will it interface with my drivers, vfd, and tool sensor without any issues?
Has anyone done this conversion that can weigh in?

Here is the board for reference (https://cnc4pc.com/c94-multifunction-board-b.html)

I attached a few photos of my control box for reference.

Thank you everyone!