Is it bad to rotate an unpowered stepper motor?
I want to set up my limit switches,, but I don’t have my G540 set up yet. So I was going to use a drill on the back side of my 2 shafted stepper motor to move my axis’s. Will this harm the stepper motor?
Or I will have to take off my motors and set up couplers and a shaft.
Thx EZ
Results 1 to 4 of 4
Threaded View
-
12-20-2023, 05:57 PM #1
Member
- Join Date
- Aug 2022
- Posts
- 37
Rotating unpowered stepper motor, good or bad
Reply With QuoteSimilar Threads
-
Stepper motor only rotating one direction (RAMPS 1.4 Board)
By L4_Topher in forum Stepper Motors / DrivesReplies: 8Last Post: 10-12-2020, 04:10 PM -
Stepper motor size for 4x8 Router? (all axis ball screws - rotating nut on long axis)
By denhen89 in forum Stepper Motors / DrivesReplies: 8Last Post: 08-14-2017, 10:29 AM -
stepper motor not rotating
By Haitem56 in forum Stepper Motors / DrivesReplies: 35Last Post: 03-08-2017, 02:32 PM -
UIROBOT:stepper motor,linear stepper motor and stepper driver Yahoo Group
By uirobot in forum Community Club HouseReplies: 0Last Post: 02-26-2013, 08:37 AM -
Stepper rotating weight, why?
By Spiral_72 in forum Mechanical Calculations/Engineering DesignReplies: 0Last Post: 05-14-2009, 06:19 PM
Tags for this Thread
Posting Permissions
