Hi All,

I have been working on enabling macro B on my Fanuc 0M-C but it seems like it does not "stick".
(param 912 Macro A is also 0x00)

My sequence is as follows:

machine on -> pwe 1 -> estop -> parameter 913 set to 10000000 -> input -> get p/s 000 error. I was in mdi mode when trying to edit it. Write protect key (allow write).
Have tried a re-start and re-boot (as that is what error 000 means) but that does not seem to help.

Al_The_Man Seems to remember the following:
"... many of my notes are no longer around, there is a parameter to set to allow it to be enabled which I cannot find at the moment. will keep on looking."

Perhaps somebody else seems to remember it?