Hi was wondering if anyone can confirm that my logic is good before I power up for the first time? I just received a new StepperOnline T6 series 1kw servo drive and motor kit. In the video they show someone one powering it using a 24v power supply for testing but the manual says its rated for 220v single phase. What I'm hoping what I can do is power it directly from a 120v wall outlet. Is this ok to do this and what's the draw back of using 120v instead of the rated 220v? Also does it matter what the order is on the neutral an hot leads go on the drive? In the manual all it shows is an L1 and L2 then on the bottom is a ground? Thanks