Hello all,
First time posting here. Yesterday I ran one of the Wizards for the first time.
This Wizard being the Nesting Wizard. It is one of the Wizards that came with Mach3. Well, I was under the impression that a nesting program would offset your g-code by the required amount to allow for multiple pieces to be cut from the same program file. Well Nesting Wizard would not offset the G-code. It would simply start all over again in the same location. Now I didn't take the time to look through the G-code to see what it was doing. Only because of time, and I thought that's what the Nesting Wizard was supposed to do.
Any Idea's

TIA
Peace
Neil