I just purchased a Tormach tooling system to use with my Sieg. I got everything I want with one little problem. I have a high quality keyless drill chuck with a JT3 mount. The problem is that Tormach doesnt sell a JT3 adaptor for use with their system. I believe I could make one since I purchased a great deal of tooling to go with my new lathe but I dont know the taper angle or how to figure it out. According to the wikipedia the small end is .7461 inches in diameter and the large end is .8110. The overall length is 1.2188. I know with this info you should be able to algebraically figure the angle out but I don't remember how. Has anybody else run into this problem and solved it. I am ordering a JT6 mount and was also considering turning a boot to fit over the JT6 mount and to mate to the JT3 mount. Any feeback is welcome, especially for the boot idea since it doesnt seem that good of an idea to begin with.