[ArturoV]

Arturo, To change the datum position, are you using laser cut 5.0? If yes you can try : from the software catalogue:


Datum Dir (Datum Direction)
. It is determined by the position (right or left, up 0r down) of original switch

Luis

Luis,

Thanks for the tip. I made that chance but still dont see any results. I tried sending my drawings but it doesnt want to go to the upper right hand corner nor does it want to engrave.It does cut fine,but when I send something small to engrave it doesnt shoot out any laser. Let me know If you have any more tips.

Gracias,

Arturo.