I have just finished converting my homebuilt 3 axis Router machine over to a Plasma.
It has a Hypertherm 1000 plasma with machine torch, and it is using a Campbells THC300 Torch Height Control.
Everything seems to be working as it should
I have been using the 60amp nozzles that came with the Plasma, and I also have some Finecut consumables.
I will mainly be cutting 16swg / 10swg

I am having a major problem getting good cut quality, because I just don't know what to start adjusting!
I am just going around in circles!

I have acheived 'Laser' perfect cuts by hand when I tested the plasma before I attached it to the machine, so I know that the air is clean and the plasma can acheive good cuts!
So what do you test-cut to get the best set-up, and in what order do you adjust the different settings

Amperage
Tip Voltage
Cut Height
Cut Speed
Air Pressure

I have wasted a load of material trying to get a good cut, I did manage to get a good cut once, but in my speed I did'nt write the settings down....

Any help would be much appreciated.

Thanks

Andy