Hi all,

I have 2 24VDC geared motors, which supposed to be running at the same speed.

Both motors are supplied with same 24V source. 1 was measured to turn 1 round at 70secs, the other at 61secs, which came out a ratio of 70/61=1.1147

Each motor was measured to draw around 6amp.

I'm thinking if I could just step down the 24V source on 1 motor side to 24/1.1147=21.5V, so that both motors will run at the same speed?

Hence I'm thinking of using 1kohm and 10kohm resistors for the voltage divider.

How do you guys think? Thanks.

Rgds.