Here is a picture of the new Miil Guides I am installing. They are 5 inchs longer for a total of 20 inches and fit tighter in the bore by .001. They are chrome plated 1045 steel. We started to make the new lift screw using B7 5/8"-8 acme all thread. The lift motor is a 1/6 hp 57 RPM 115volt gear motor. The lift nut will be modified by boring out the center and threading the flange and installind a bronze nut that is taped to size.
Thread: Mill Column Mods
Results 1 to 9 of 9
Threaded View
-
03-18-2008, 01:57 AM #1
Registered
- Join Date
- Nov 2007
- Posts
- 277
Mill Column Mods
Reply With QuoteSimilar Threads
-
Knee Mill vs Square Column Mill
By SCzEngrgGroup in forum Bridgeport / Hardinge MillsReplies: 0Last Post: 11-10-2007, 01:27 AM -
Some R45-7045 mill mods
By davo727 in forum Charter Oak Automation Support ForumReplies: 22Last Post: 05-29-2007, 03:28 AM -
helpful mods for a grizzly mill
By omegaghost in forum Benchtop MachinesReplies: 4Last Post: 02-05-2007, 05:57 PM -
Mods to my mill
By Richards in forum Charter Oak Automation Support ForumReplies: 4Last Post: 11-02-2006, 08:51 PM -
HARBOR FREIGHT small round column mill to a square column conversion.
By motomitch1 in forum Vertical Mill, Lathe Project LogReplies: 25Last Post: 12-01-2005, 05:24 PM
Posting Permissions
