I did some checking and found that the Side Mount Tool Changer on the VF2 is 94".

My garage door is 94.5" (I can get 95" by removing the trim.) So, I need to figure out how to "slide" the machine into the shop. I know for a fact that the garage door header is non-bearing so notching (if completely necessary) would be an option.

I was thinking that I could build a dolly of some sort that I could lift the mill a 1/4" or so off the ground. Just enough to make it mobile!

Are the 2 slots in the front of the mill for a fork lift?
http://www.haascnc.com/VMC_specs.asp...0#VMCTreeModel

The HAAS rep didn't know with conviction weather or not the height of the tool changer was my only height concern. Can the other components be removed to clear my door?