I am working a belt drive conversion for my X3, not sure If I will make there as my motor and drive train sounds like it is about to explode. So I am in need of some advice on the following.
1. Spindle bearings to handle 4000rpm
2. Motor upgrade(not breaking the bank)
Results 1 to 8 of 8
Threaded View
-
05-02-2008, 02:33 AM #1
Member
- Join Date
- Apr 2003
- Posts
- 610
Looking for Motor upgrade suggestions for X3 w/Belt drive
Donald
Reply With QuoteSimilar Threads
-
lathe motor mounts with belt drive X-Z steppers
By PoolQ in forum Mini LatheReplies: 2Last Post: 04-12-2008, 06:16 PM -
Need Sherline Belt & qestion on X2 Belt Drive?
By Oldboy in forum Benchtop MachinesReplies: 12Last Post: 03-06-2008, 07:42 AM -
Need to upgrade my 1/8hp Taig motor. Need suggestions.
By antelnation in forum Taig Mills / LathesReplies: 9Last Post: 01-02-2008, 12:50 PM -
Stepper Motor Belt Drive Side Load Question
By harryn in forum Stepper Motors / DrivesReplies: 3Last Post: 08-07-2007, 11:23 PM -
Motor and belt mounting suggestions
By Gads in forum Mechanical Calculations/Engineering DesignReplies: 1Last Post: 03-08-2006, 07:40 AM
Posting Permissions
