[jeep534]

Hello again,

I have a Haydon Big Inch step motor. It is 12VDC, 4W, 4 wire bi-polar with a serial connector. The black is common to the limit switches and blue and red are each connected one to each limit switch. It is a rack and pinion setup per se on an optical that I am using the motor for adjusting focus.

We have previously used stepper test but it lacks the capabilities for checking this motors capabilities properly. Can your software do the job?

Please advise,
Thanks in advance.

John Franz

John, you need to post this question in the servomotors and drive section of the forum

thanks
archie =) =) =)