Hi I have obtained a Control Techniques unit that was connected to a Cincinnati Arrow 500 in a local college. the load screen says its 1995. I have been told by the technican that it has the drive boards in it and all the contols work including the electronic handwheel. It looks like an Acramaitc 2100 unit. There is a 9 pin din output socket on the side of the unit. The question is shall I dump it or use it on my Denford Triac with a knackered control board? Any help would be appreciated, especially as I'm thick as two short planks when it comes to electronics
Jimthefish
Results 1 to 6 of 6
Threaded View
-
10-11-2008, 02:02 PM #1
Registered
- Join Date
- Oct 2007
- Posts
- 6
Offline control unit from a cincinnati Arrow
Reply With QuoteSimilar Threads
-
Cincinnati milacron arrow 500
By shmoo in forum Uncategorised MetalWorking MachinesReplies: 24Last Post: 12-10-2014, 10:33 PM -
Cincinnati Arrow 500
By Mr Bonavita in forum CNC Machining CentersReplies: 4Last Post: 07-02-2009, 07:24 AM -
Cincinnati Arrow 500 Setup
By professor in forum CNC Machining CentersReplies: 2Last Post: 11-13-2007, 10:34 PM -
Moving a Cincinnati Arrow 500
By professor in forum MetalWork DiscussionReplies: 4Last Post: 10-19-2007, 10:03 PM -
Cincinnati Arrow vs Sabre
By MITYDR in forum Uncategorised MetalWorking MachinesReplies: 1Last Post: 07-20-2007, 11:35 PM
Posting Permissions
