Searching for post for a 3 axis gantry mill with a Heidenhain 426 control. Need it for 2D & 3D toolpaths in ISO. I am using MasterCam v9 & MX2. New to this site. Might take a bit to figure this out.
Ken
Results 1 to 2 of 2
Threaded View
-
01-30-2009, 07:14 PM #1
Registered
- Join Date
- Aug 2005
- Posts
- 4
Need Heidenhain 426 ISO post for MasterCam v9 or MX
Reply With QuoteSimilar Threads
-
Heidenhain TNC 145 post for MasterCam X2
By Muggs in forum Post Processors for MCReplies: 7Last Post: 12-06-2007, 01:35 AM -
Need Heidenhain TNC151 post for Mastercam 8.1
By Huntersyv in forum Post Processors for MCReplies: 2Last Post: 01-14-2006, 04:49 AM
Posting Permissions
