When I try to turn less than 10 mm dia mild steel rod using a carbide tool (55 deg diamond-shaped, sharp radius), I am not getting good surface finish. It has non-uniform appearance. Any suggestions?
Thanks.
Thread: poor surface finish
Results 1 to 4 of 4
Threaded View
-
02-03-2010, 05:11 AM #1
Registered
- Join Date
- Feb 2006
- Posts
- 1792
poor surface finish
Reply With QuoteSimilar Threads
-
Poor surface finish
By pmsmichelle in forum MastercamReplies: 2Last Post: 02-05-2010, 03:54 PM -
bad surface finish
By tunitime in forum MetalWork DiscussionReplies: 6Last Post: 10-25-2009, 05:35 PM -
Surface finish
By chakaloso in forum Uncategorised MetalWorking MachinesReplies: 0Last Post: 06-13-2007, 02:54 AM -
Surface finish
By d.a.v.e in forum Mechanical Calculations/Engineering DesignReplies: 1Last Post: 11-10-2006, 08:35 PM -
32 surface finish
By mroy0404 in forum MetalWork DiscussionReplies: 4Last Post: 05-29-2006, 03:02 AM
Posting Permissions
