Hey guys......

I was milling wood tonight ( a plug for an rc airplane wing) with a .25 2 flute upcut bit, 13000 RPM, cuttin beautiful..... I was inside when I heard something sounding differant and the machine was going but the bit had broken....

Well I looked at my G-Code and I cannot find a problem.... Im just stumped...

Any suggestions what to look for ?

Would you run the code again or recode the part ?

The 'crash' by the way was a shallow cut 1/2" long and about .25 deeper than the rest..... it shouldnt have even broke the bit really - Im stumped....