here's the problem

i have limit switches at the end of my table if i acidenly hit one i get stuck there

it wont let me move the table back
i have to shut down my driver board and manually move away

this sucks because i lose my step position

its there a buton on mach2 thats acts like an (end of stroke releise) and would let me move the table away from the limit under power?

i was thinking of wireing the grounds of my limits switches to a normally closed button on my control box. so i could bipass my limit switch alowing me to move away from the end of travel under power so i wouldnt lose my steps.

is there a better way?