I am trying to run a Newing Hall engraver by a Xenetech controller/software. There are many engravers worldwide who do this sucessfully. I even have a custom cable from Xenetech to achieve this. My problem is that many times the engraving just goes all over the place, as the NH is used primarily to engrave customers own items e.g. pens, trays, cups, bracelets etc. it is impossable use, even after a trial run on a piece of clear acitate, Murphy's law dictates that when engraving the actual item it screws up! One engineer says it could be that the amps on the NH are different than those on the Xenetech table, which causes it to engrave all over. I dont know if this explanation is logical or why other engravers have no problem using this set up.

Any help would be appreciated
David