I see that this area does not get much traffic. Not sure I will get an answer to this question.

I just reloaded my old 9.2 version of Turbo CAD. I spent 30 minute trying to make a block with 3 small cut outs in the edge. Still could not find the button to erase the connecting line. It looks like it will do a lot, yet it also looks like a steep learning curve.

I tried Sketchup for the first time and did the same block in about 5 minutes. Sketchup is easy to use but when it came to some angles I was trying, I had problems with it.

So if I get the newer version of TurboCAD, is it worth the money? Is it easier to use then the old 9.2?


Thanks for any help.


Buzz