Well, the title of the thread says it all.
I'm well on the way to finishing the Mechanical side of my CNC MiniMill and about to start on the Electronics & Software.
I would like to share, (sponge), ideas with others in the Capital City area.
Results 1 to 20 of 40
Threaded View
-
06-07-2005, 11:07 AM #1
Registered
- Join Date
- May 2005
- Posts
- 89
Any Wellington Area CNC Builders out there?
Reply With QuoteSimilar Threads
-
Using your CNC Mill as a CNC Lathe
By lstool in forum Knee Vertical MillsReplies: 11Last Post: 06-12-2017, 02:29 PM -
Building CNC Surface grinder - whole lotta questions
By rashid11 in forum Uncategorised MetalWorking MachinesReplies: 6Last Post: 03-09-2006, 09:53 PM -
The start of a big CNC project...
By UKRobotics in forum Uncategorised MetalWorking MachinesReplies: 10Last Post: 09-30-2004, 11:34 PM -
CNC Builders Creed
By ynneb in forum Community Club HouseReplies: 19Last Post: 03-12-2004, 06:06 PM -
Any CNC Builders in Austin Texas
By Mr.Chips in forum DIY CNC Router Table MachinesReplies: 24Last Post: 10-16-2003, 04:48 AM
Posting Permissions
