I got my Powermax65 last week and got around to hooking it up and doing a few test cuts. Cuts are on par with the 45 but I can go a lot faster now. 3/8" and 1/2" are much better with the 65.



Hooking up the arc volt wires.


I added two pins on the cpc port for the arc volt wires. All the other pins are the same as the 45. If you need to run the hand torch like I am, you jump the orange and yellow wires going to the torch together to allow it to fire.


Cuts made with 65 amps. 3/16",1/4",3/8" and 1/2". Two sides have no bevel but the other two have a few degrees of bevel.


Ryan