588,246 active members*
4,219 visitors online*
Register for free
Login

Thread: Pushing the limit of my 7 x 10

Results 1 to 6 of 6

Threaded View

  1. 02-07-2011, 06:22 PM #1
    wam
    wam is offline Registered
    Join Date
    Aug 2003
    Posts
    64

    Pushing the limit of my 7 x 10

    I needed to make some dies for a 3 roll bender I am building. I though hey...I have a lathe no problem.... The dies have a 4" diameter and are 2 1/2" thick. I had to purchase a 5" chuck from LMS to turn these bad boys. I also had to remove some of the cross slide pieces and make a new tool post mount.
    Attached Thumbnails Attached Thumbnails dies.jpg  
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Getting close to pushing the button.... (SV-2412S)
    By spencer313 in forum Sharp CNC
    Replies: 0
    Last Post: 04-20-2008, 03:36 AM
  2. Limit Switches
    By Haydn in forum DIY CNC Router Table Machines
    Replies: 1
    Last Post: 12-18-2006, 09:19 PM
  3. Pushing electrons the other way ?
    By whitney in forum CNC Machine Related Electronics
    Replies: 1
    Last Post: 10-03-2006, 03:39 AM
  4. pushing pinion against gear rack
    By DanOSB in forum Mechanical Calculations/Engineering Design
    Replies: 2
    Last Post: 02-19-2006, 05:02 AM
  5. Limit switches
    By Chunky in forum DIY CNC Router Table Machines
    Replies: 4
    Last Post: 06-06-2005, 03:28 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules