Hello -

working with the 0.9.8 demo. Pretty new here - been using G-simple for about 9 months on my converted X2.

So far liking what I see - but in first test file I've made I have a problem. When I run the simulation in Mach 3, the feedrate never goes above 1.

I have cut feedrate set to 10, and plunge set to 1.

Stepover feedrate is set to: cut feedrate.

Even from the start, when moving into position, feedrate remains 1. Mach 3 shows the correct speedrate in the set value...yet it runs at 1/10th. Finally, using cncsimulator the feedrates appear to be fine. I am using the Mach3 post-processor output setting in CAMBAM.

Suggestions?

Bill